Filter
Top Products
Additional
Information
103
E
Screen Displays
To display the date and time, press the
wireless controller’s DATA CODE
button. See also p. 68.
Press the wireless controller’s TV
SCREEN button or turn TV SCREEN
on through the camera menu to see the
other displays on the TV screen. (The
displays appear white on-screen.) They
will not be added to any recordings you
make with the camera. For instructions
on how to hook the camera up to your
TV, see p. 30.
indicates a flashing display.
Record pause mode
( 18)
Recording ( 19)
The backup battery is
not properly installed,
or needs replacing
( 90).
Shows how much
battery power remains
( 88).
The battery pack is
exhausted ( 88).
No cassette is loaded,
or it is set for erasure
prevention
( 16, 17).
TV
SCREEN
DATA
CODE
REC
PAUSE
END
5min
EJECT
Remaining tape
(Green: more than
five minutes.
Yellow: less than five
minutes.
Red: final few
seconds.)
...finally, it tells you
when you have
completely run out of
tape.
The camera is ejecting
the tape ( 16).
The safety mechanism
is activated. Unload
the cassette and turn
the camera off. Turn it
on again and reload
the cassette.
Recording mode
( 20)
EJECT
PS
Turning off the LCD screen displays
You can turn off the displays to give you a clear screen for playback.
Set the camera to VCR mode, open the VCR menu and choose the DISPLAYS
option. Set the displays to OFF and then close the menu.
• The LCD screen will now be completely blank, but the camera will continue to
show warning/caution displays when necessary.
5_ZR10_E(86-112) 3/9/00 8:01 PM Page 103 (1,1)