Filter
Top Products
Editing
82
E
1. Open the VCR menu, select AUDIO DUB.
2. Select AUDIO IN or MIC. IN and close the menu.
3. Locate the point where you want to start audio dubbing, then press
the PAUSE button.
• You can use the playback buttons on the body of the camera or the special
playback functions on the wireless controller in the same way as in playback
mode.
• The camera becomes set to playback pause mode.
4. Press AUDIO DUB.
• AUDIO DUB. and appear on the display.
5. Press the PAUSE button (and start play on the other audio device
if AUDIO IN).
• Audio dubbing starts.
• If MIC. IN, direct your voice into the microphone.
• changes to .
AUDIO DUB.••AUDIO IN
( 36)
CAMERA
OFF
VCR
POWER
REW
PLAY
FF
REC
PAUSE
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
A/V
INSERT
PAUSE
SLOW
+ /
– /
×2
Use the wireless controller when dubbing audio.
Do not connect/disconnect any cables to/from the camera when dubbing audio or
preparing to dub audio.
Preparations
Dubbing
Turn the camera’s POWER switch to VCR and load a recorded cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed
position).
4_ZR10_E(73-85) 3/9/00 7:58 PM Page 82 (1,1)