Filter
Top Products
46
Snapshot Tutorial
Selecting “On” causes the front lamp to turn on for illumination
when shooting under low lighting conditions.
1. In the REC mode, press [SET].
2. Use [8] and [2] to select the third Control Panel
option from the bottom (REC Light).
3. Use [4] and [6] to select “On” and then press [SET].
• y (REC Light) is displayed on the control panel while the REC Light is
enabled.
IMPORTANT!
• Never look directly into the front lamp while it is lit.
• Never aim the front lamp at a person who is operating a motor vehicle, etc.
• The effectiveness of the REC Light is reduced in the case of faraway subjects.
When shooting people, the face detection feature detects the faces of up to ten
individuals and adjusts focus and brightness accordingly.
1. In the REC mode, use [4] and [6] to display G in the control panel,
which enters the Face Detection.
•If G does not appear in the control panel, press [4] or [6] many times until it
appears. Each press of [4] or [6] will cycle the control panel option in the
following sequence: Face Detection * Make-up Mode (page 48) *
Landscape Mode (page 49).
2. Press [SET] and then use [8] and [2] to select the second Control
Panel option from the bottom (Face Detection).
3. Use [4] and [6] to select “G Face Detection: On” and then press
[SET].
Shooting with the REC Light (REC Light)
Using Face Detection (Face Detection)
Front lamp