Filter
Top Products
Cisco Unity 3.1(6) Installation Guide: Installing a
Windows 2000 Server for Component System
Document ID: 44332
Introduction
Prerequisites
Requirements
Components Used
Conventions
Task 1: Start the Windows 2000 Server Initial Installation
Task 2: Complete the Windows 2000 Server Initial Installation
Task 3: Complete the Message Queing Configuration
Task 4: Install Additional Windows 2000 Languages (Optional)
Task 5: Install Internet Explorer 5.5 with Service Pack 2
Task 6: Install MSXML3 and MSXML3 Service Pack 1
Task 7: Install Windows 2000 Server Service Pack 3
Task 8: Install the MS03−007 Hot Fix
Task 9: Change Windows Explorer Settings (Optional)
Task 10: Attach the Network Cable to the Server
Task 11: Verify IP Connectivity
Task 12: Configure Internet Explorer for the First Time
Appendix A: Create Bootable Installation Floppy Disks (Optional)
Appendix B: Configure the Most Common TCP/IP Parameters
Appendix C: Change the Name of the Computer Name (Optional)
NetPro Discussion Forums − Featured Conversations
Related Information
Introduction
Note: This document is part of a set of documents that explain how to determine which Cisco Unity
installation option is correct for your network. These documents also explain how to install the correct Cisco
Unity option in your network. These documents are intended to be used for new Cisco Unity installations
only. If you are upgrading or otherwise changing an existing Cisco Unity configuration please refer to the
correct online product documentation for Cisco Unity.
Note: These documents do not explain how to integrate your Cisco Unity server with your phone system or
how to configure your Cisco Unity server. Once you have completed the initial Cisco Unity installation, you
will be referred to the online product documentation for further instructions. Refer to the Next Steps section
on the Index page.
Note: This document set is written for networks that run a Windows 2000 server.
Note: Return to the Index page for this documentation set.
There are two types of systems that Cisco Unity can be installed on:
Base Line System (BL): A baseline system is a server that is purchased from Cisco or a Cisco
reseller and that is shipped with a Platform Configuration CD. These systems include a copy of
Windows 2000 Server.
•
Component System (CS): Purchased as separate pieces (software and hardware), and all software•