Filter
Top Products
5
Cautions for Set-up
・ Prior to operation, read “For Safe Operation” carefully and observe the rules therein.
・
Use care when moving the printer. Never try carrying the printer alone.
Dropping it could cause injury or damage to other property.
・
Do not use or store the printer near fire, excessive moisture, in direct sunlight, near an air
conditioner or heater, or any other source of unusually high or low temperature or humidity, or
excessive dust.
・
Do not place the printer where chemical reactions occur, such as in a laboratory.
・
Do not set up the printer where there is salinity or corrosive gas in the air.
・ The printer must sit on a firm level surface where there is ample ventilation.
・
Do not put anything on the top of the printer.
・
Do not place the printer near a radio or television, and do not use the same wall outlet for the
printer and radio or television. Radio or television reception could be adversely affected.
・
Do not use a power voltage or frequency other than those specified.
・
Do not put anything on the power cord or step on it.
・
Do not drag or carry the printer by the power cord or USB cable.
・
Avoid plugging the power cord into an outlet with many loads.
・
Do not bundle the power cord.
・ Always grip the plug housing, not the cord, to plug/unplug the power cord.
・
Make certain the power is turned off before connecting/disconnecting the USB cable.
・
Avoid lengthening the signal cable or connecting it to any noise-producing device.
If it is unavoidable, use a shielded cable or twisted pair for each signal.
・
Place the printer near the outlet where the power cord can be unplugged easily to shut off
power.
・ Use an AC outlet that accepts a three-pronged plug. Otherwise, there may be danger of electric
shock.
・
Use the appropriate specified cord set.
Only use items that are certified safe according to the standards of the country where they are to
be used.