FlexCam iCam Digital — Getting Started
11
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
FlexCam iCam Digital — Getting Started
10
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Sofware drivers for Macintosh
Before you can connect your FlexCam iCam Digital to a Macintosh, you must install the
USB drivers.The drivers are found on the USB Software and Driver Disk that came with
your camera.The FlexCam iCam Digital is compatible with Mac OS 8.6 – 9.2.
To install USB drivers on a Mac
1. Insert the
USB Software and Driver Disk
into the CD-ROM drive.
2. Double-click the
USB Software and Driver Disk icon
to open the CD content window.
3. Double-click the
FlexCam iCam Digital folder
icon.
4. Double-click the correct operating system folder.
5. Click
iCam Digital
to install drivers. Once drivers are installed, restart the computer.
6. Plug the
USB cable
into a USB port on the Mac.
Figure 11.ArcSoft on Mac
Installing ArcSoft Software
To install ArcSoft Software on Windows
1. From My Computer, right-click the
ArcSoft CD
icon and select
Explore
.
2. Double-click
Setup.exe
.
3. Follow the on-screen prompts. Both programs are installed through the same installation
wizard.
4. Restart your computer.
To install ArcSoft Software on a Mac OS
1. Double-click the
Video Impression 1.6 Installer
icon (see Figure 11) and follow the
on-screen prompts.
2. When Video Impression finishes installing,double-click the
PhotoStudio Installer
and
follow the on-screen prompts.
3. Restart your computer.
Figure 13.Installing the ArcSoft programs
Figure 12.iCam Digital driver installer