Filter
Top Products
10
ENU
USING THE FLASH
1. Press the button to select the desired resolution.
2. Press the
button to toggle through the following options and select your desired flash and
exposure settings:
Flash OFF/Outdoor ‡ Auto flash/Outdoor ‡ Flash OFF/Indoor ‡ Auto flash/Indoor ‡ Flash ON/Indoor
‡Flash ON/Outdoor.
3. Frame your subject through the viewfinder.
4. Hold the camera steady and press the Shutter button firmly to capture an image.
Note:
1. If the flash is charging , the flash icon on the status LCD will blink. The camera will not capture an
image while this icon is blinking. Wait for the icon to stop blinking before capturing an image.
2. The flash will yield best results when the subject is 5 to 6.5 feet (1.5 to 2 meters) away from the
camera. The image may be over exposed if you hold the camera too close to your subject (e.g.less
than 5 feet or 1.5 meters away.)
3. The flash setting will be deactivated to the flash off mode if the battery indicator shows only one
segment. Change or recharge the battery to replenish power before using the camera with the flash.
4. The flash is deactivated in the Movie mode.
USING THE SELF-TIMER
1. Press and hold the button to turn on the camera.
2. Press the
button until the self-timer icon displays on the LCD. The camera will automatically
adjust to the native (two-star) resolution setting (1280 x 1024).
3. Place your camera on a tripod (or a flat surface) and frame the subject through the viewfinder.
4. Press the
button to select your desired flash and exposure settings.
5. When ready to capture an image, press the Shutter button once to start the timer. The camera will
beep and the red LED will blink slowly. As the time counts down to 3 seconds, the camera will beep and
flash faster.
Note:
1. The self-timer function only functions at 1280 x 1024 resolution (two-stars.)
2. The Self-timer remains activated after the image is taken. To deactivate the Self-timer, press the
button to go to the other mode setting, or just turn off the camera, then turn the camera back
on.
USING THE CONCORD 1500
1500 UG-ENU (516167-00).indd 101500 UG-ENU (516167-00).indd 10 10/22/04 2:46:06 PM10/22/04 2:46:06 PM