Filter
Top Products
ESPAÑOL
ENGLISH
FRANÇAIS
DEUTSCH
PORTUGUÊS
DS8118 Manual-6 Lang. (086-002937-017)
PORTUGUÊS
ENGLISH
FRANÇAIS
DEUTSCH
ITALIANO
ITALIANO
ESPAÑOL
ATTACHING THE STRAP AND LENS CAP
SECURE DIGITAL (SD) AND MULTI-MEDIA CARD (MMC)
The Secure Digital (SD) and Multi-Media Card (MMC) are external memory cards
that can be plugged into your Digital Camera to extend the memory capacity. Please
refer to (
p.29) for the list of memory cards compatible with this digital camera.
When an external card is installed,
will be displayed on the Status LCD.
It is recommended that all memory cards are formatted using the Format
option (
p.15) before using them with this digital camera. Memory cards
formatted using other devices may be incompatible.
When the SD card is installed, all images and movies taken are automatically
stored on the card. Images and movies in the internal memory cannot be
accessed until the card is removed.
The SD card will not insert fully into the slot if it is facing the wrong way. Be
careful not to apply undue force to the card.
Attaching the Strap Attaching the Lens Cap
1. Pass the short,
thin loop of the
strap through
the camera’s
strap hole.
2. Pass the
other end of
the strap through.
3. Tighten by
pulling the loop.
1. Pull the lens
cap cord through
the camera’s
strap hole.
2. Pass the lens
cap through the
loop.
3.Tighten by
pulling.
4. Fit the lens cap
onto the lens.
Removing Secure Digital /
Multi-Media Card
Installing Secure Digital /
Multi-Media Card
6 7
1. Turn off the
camera.
2. Open the
battery door.
3. Insert the card
following the
printed remark.
4. Close the
battery door.
1. Turn off the
camera.
2. Open the
battery door.
3. Press the
card to release.
4. Close the
battery door.
BASIC PHOTOGRAPH
QUICK START
1. Frame your subject in the viewfinder. The frame in the middle of the viewfinder
indicates the zone of automatic focusing. You can also view the subject on the
OSD (
p.8).
2. Press the Shutter Release Button.
3. The image taken is displayed on the OSD for approximately a second (Auto
Review).
4. Once the Auto Review has finished, you may proceed to take the next picture.
When memory is full, no more images can be stored. The camera will
beep and the words “Internal Memory Full” will appear on the LCD if
you press the Shutter Release Button.
When you have finished taking your pictures:
1. Turn to Mode Dial to Off.
2. Place the lens cover securely over the lens.
1. Remove the
lens cover from
the lens.
2. Turn the Mode
Dial to Camera
Mode.
3. Check the
battery indicator,
making sure
there is enough
power ( p.4).
1. Loop the strap
over your wrist.
2. Hold the camera
firmly.
3. Avoid blocking
the lens and flash.
4. Do not move nor
remain in motion
while taking
pictures. Use a
tripod if necessary
( p.26).
Preparing the camera
Holding the camera
Taking Basic Pictures
Shutting Off the Camera