D-Link DCS-900 Digital Camera User Manual


 
6
Network Cable Connector
The DCS-900 features an RJ-45 connector for connections to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which should be Category 5 UTP twisted-pair
cable). The port supports the NWay protocol, allowing the DCS-900 to automatically
detect or negotiate the transmission speed of the network.
DC Power Connector
The DC power input connector is labeled DC 5V with a single jack socket to supply
power to the DCS-900.
Reset Button
Reset will be initiated when the reset button is pressed once and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when the Power LED begins to light up. Release the reset button and the
Power LED will begin to flash indicating that the DCS-900’s settings are reverting back
to the factory settings. The IP address will also return to the default setting of 192.168.0.20.
Connections
Rear Panel view
Ethernet Cable
Connector
DC Power Connector
Reset Button