Filter
Top Products
Lens switch
When using an auto-iris lens, set the switch according to the lens type.
VIDEO : Set to this position when using a video signal input system lens.
DC : Set to this position when using a DC control voltage input system lens.
Lens Terminals
When using an auto-iris lens, install the accessory lens Terminals on to the lens cable as
follows. Refer to the lens operating instructions regarding the lens cable signals and wire
colors.
Video signal input system lens
(Set lens switch to VIDEO.)
Note: Set the lens detector response as close as possible to AVE (Average). Hunting can
occur if set to Peak.
8