Filter
Top Products
20
2.3.2. Communication Protocol Setting
The 1
st
, 2
nd
and 3
rd
bits are used to set communication protocol. The factory default
protocol is EVF.
Notice: Please make sure the power is off before setting, and restart the
EPTZ3100/EPTZ3100I to enable a new value after changing.
Set all of protocol switches to ON; the speed dome EPTZ3100/EPTZ3100I will
enter a self-test mode.
2.3.3. Transmission Speed Setting (Baud Rate Setting)
The 4
th
and 5
th
bits on the PCB board are used to set the Baud Rate. The default baud rate
setting is 9600.
Notice: Please make sure the power is off before setting, and restart the
EPTZ3100/EPTZ3100I to enable a new value after changing.
ON
1 2 3 4 5 6 7 8
SW2
Protocol
Baud Rate
Terminal
Resistance
ON
1 2 3 4 5 6 7 8
9600 BPS 4800 BPS 2400 BPS
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
1200 BPS
ON
1 2 3 4 5 6 7 8