Filter
Top Products
SECTION 5
Handling Instructions
5.1 Electrostatic Discharge
The Fairchild Imaging Osprey camera uses TDI technology in a CCD base, and as
all such devices, has some limited inherent susceptibility to electrostatic discharge
(ESD).
All reasonable and customary design steps have been taken to provide ESD
protection circuitry.
Electrostatic charge placed at the sensor could cause charging of the chip which in
some situations might not be readily dissipated and minor impact on performance
might be temporarily experienced. Therefore, do not insert your finger or any other
object into the lens mount barrel.
5.2 Preventing ESD Damage
• Please be certain to ground yourself prior to handing the camera.
• Ensure that your working environment is grounded, including conductive floor
mats.
• Do not touch the window of the imager.
5.3 Protecting Against Dust, Oil and Scratches
• Be certain to avoid dust buildup on the sensor window, where it could block the
optical path.
• By not touching the surface of the sensor, you avoid introducing oil and avoid
scratching the sensor window. Again, you should not insert anything into the
lens mount barrel.
5.4
Cleaning the Sensor Window
• Use compressed air to blow off particulate.
• If for some reason cleaning of the sensor window is required, use lens wiping
cloth with a small amount of eyeglass cleaning fluid. Do not use solvent as it
may smear the sensor window.
Fairchild Imaging • CAM/CCD 2KCL.TDI & CAM/CCD-4KCL.TDI Line Scan Camera User’s Manual • Rev C• 26 of 30