Filter
Top Products
SETTINGS
C • B/W (color/black and white) switch setting
This switch lets you select the timing of the automatic switching of
the optical filter to color image or black and white image, according
to the subject brightness. The default setting is “L”. Set the switch
according to the brightness.
(Fig. 1)
H:for a brighter setting than L
L:Standard setting
Notes:
• After the power has been turned off, switching will restart from
color, when the power is restored.
• A sound may be heard when the color image or black and white
image is switched. Also, the image will be distorted as shown in
Fig. 1, this is normal and does not indicate a problem.
• When using infrared lighting, if there is a strong reflection on the
subject, the optical filter may switch from black and white to color
mdoe, Use only enough infrared lighting so that the mode is not
switched.
• The focus setting may be different in black and white mode and
color mode. Please check the focus setting in both modes.
TROUBLESHOOTING
Before taking the camera for repairs, please check below to make sure
that the camera is used correctly. If it still does not perform correctly,
please consult your dealer or a Sanyo Authorized Service Centre.
No picture on the monitor screen
• Is the power turned on to all connected devices? Is the voltage correct?
• Are all the signal connecting cables correctly connected?
• Is the lighting sufficient?
• Has the lens cap been removed?
• Is the lens type (DC or VIDEO) correctly selected?
Depending on the type of lens, the A. I. LENS switch must be set
accordingly.
• Is the iris control correctly set?
The picture is not clear
• Is the monitor correctly adjusted?
• Is the flange-back position correctly set?
• Is the lens focus correctly adjusted?
• Are the lens surfaces clean?
If there is dust or finger prints on the lens, the image quality will
deteriorate. To clean the lens use a soft cloth or a commercially
available lens cleaning set.
SERVICE
This camera is a precision instruments and if treated with care, will
provide years of satisfactory performance. However, in the event of a
problem, the owner is advised not to attempt to make repairs or open
the cabinet. Servicing should always be referred to your dealer or
Sanyo Authorized Service Centre.
C-BW
L
H
L53S4/US GB 1998, 10, 27
14 English