Filter
Top Products
SETTINGS
White balance adjustment
Normally the switch
7
(
WB
) is set to the down (
ATW
: auto white
balance) position and the white balance is adjusted automatically. If a
manual white balance adjustment is necessary, follow the steps below.
Set the switch
7
(
WB
) to the up (
MANU
: manual) position, then
adjust the color.
• Turn
R
(VR302) to set the red ratio and/or
B
(VR303) to set the
blue ratio.
Synchronization settings
The default setting is internal synchronization (
INT
). You can change
the power supply synchronization by moving switch
8
to the up (
LL
)
position. Refer to “
Line phase adjustment
” for details.
Line phase adjustment
When using a camera switcher to connect 2 cameras or more to one
monitor, there may be a vertical roll of the images when switched. In
such a case, set as described below.
1
Set the switch
8
(
SYNC
) to the up (
LL
) position.
2
Switch the display on the monitor from camera 1 to camera 2.
Adjust the
PHASE
volume on camera 2 until the vertical roll of the
image stops.
If more than two cameras are used, please repeat this procedure
for all the cameras.
CAUTION:
If the vertical roll cannot be corrected by setting the
PHASE
volume
on camera 2, try setting the
PHASE
volume on camera 1. If it still
cannot be corrected, please check that the polarity of the power
cords of all connected devices is correct.
7
VR302VR303
B
R
WB
8
VR322
PHASE
L5AK4/US, L5AL4/US GB 2003, 6, 6
English
9