Filter
Top Products
20
Changing the date and time
1Press the “MENU/OK” button.
2Use “d” or “c” to select “gOPTION” and
then use “a” or “b” to select “SET–UP”.
3Press the “MENU/OK” button.
4Select “DATE/TIME” and press “c”.
See P.18 for information on setting the date and
time.
0103 0204
◆
Power Save Function
◆
If the camera is not used for 2 minutes, this
function automatically switches it off.
When this function is enabled, the screen
switches off to conserve battery power if the
camera is not used in any way for 30 seconds
(See P.82 for details). To switch the camera
back on, turn the Power switch to “OFF” briefly
and then back to “q”.
◆
Checking the remaining batteries charge
◆
Switch the camera on and check that no battery
level warning (
Z or X) is displayed on the
LCD monitor. If no icon is displayed, there is
ample charge left in the batteries.
i
X Lit red:
Batteries charge low. Replace or recharge the
batteries as they will run out shortly.
i
C Blinking red:
The batteries are exhausted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the batteries.
●
!
Do not reuse batteries that have no remaining
charge (C blinking red) as this can result in faults
such as the camera switching off without retracting
the lens.
●
!
The above estimates are for the Still image modes.
In Playback mode, the transition from “X” to “C”
may take less time.
SETTING THE DATE AND TIME