Filter
Top Products
38
Troubleshooting
Intelligent Face
Detection
Cannot set
Intelligent Face
Detection.
The Shooting mode is set to ,, ., ,
, , or .
Change the Shooting mode.
Macro
Cannot set the
camera to Macro
(close-up) mode.
The Shooting mode is set to H, ,, .,
/, , , , , or .
Change the Shooting mode.
Flash
Cannot use the
flash.
The shutter button was pressed while the
flash was charging.
Wait until the charging is completed before
pressing the shutter button.
The flash is not popped up. Pop up the flash.
The Shooting mode is set to , ,, ,
, or .
Change the Shooting mode.
The batteries have run out. Load new or fully charged batteries.
Continuous shooting is selected. Set continuous shooting to OFF.
> Super macro mode is selected. Cancel > Super macro mode.
The flash settings
are restricted and
cannot be
selected.
The Shooting mode is set to anything other
than H and N.
The flash settings are restricted because the
camera settings are tailored to the scene being
shot. Change the Shooting mode for a wider range
of flash settings.
The playback
image is dark
even though the
flash was used.
The subject is too far away. Move to within the effective flash range before
taking the picture.
Your finger was covering the flash. Hold the camera correctly.
Photographed images
The image is
blurred.
The lens is dirty. Clean the lens.
AF frame (lit red) and { appeared when
taking pictures.
Check the focus on the subject and take pictures.
appeared when taking pictures. It may cause camera shake. Hold the camera
steadily.
There is speckling
on the image.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
This is a characteristic of CCDs and does not
indicate a camera fault.
Matters Problems Possible causes Solutions
L310GB.book Page 38 Thursday, January 17, 2008 9:44 PM