Filter
Top Products
105
4.7 Replacing the Back-side Lamp
4
REPLACEMENT OF CONSUMABLES
5. Install the Back-lamp unit in the reverse order of its removal. Make sure the
connectors meet properly.
6. Close the side cover. Confirm that the cover is closed securely.
7. Clear the Rear-side lamp counter.
Please refer to the section “7.3 Setup Mode Details,” “9. Abrasion counter reset.”
3
HINT
You can check the cumulative lamp on hours
from the operator panel Test mode.
For the details, refer to the section "7.5 Test
Mode Details," "3.Display the cumulative lamp-
on hours."