Filter
Top Products
7
1.3 Basic Operations of the Operator Panel
1
BASIC SCANNER OPERATIONS
■ Lifting or lowering the hopper
When the scanner has no error state (Check LED is not lit), pressing (Previous button)
lifts the hopper and pressing (Next button) lowers the hopper.
The function is valid when:
- Read LED is not lit
- The scanning operation is not in progress
- The scanner is not in test mode (excluding Single feed and Multi feed)
- The scanner is not in setup mode
The hopper stops at the pick position or at the 250-, or 500-sheet position, depending on the
hopper height adjustment in setup mode. At the pick position, the top paper of stack (the
hopper table when no paper is loaded on the hopper) is aligned to the Pick roller. At the 250-
sheet position, for example, the hopper table can load about 250 sheets of paper. Each time
you press (Previous button) or (Next button), the hopper lifts or lowers by one
position. By pressing (Previous button) when loading documents, the hopper lifts up to
the pick position.
CAUTION
During hopper height adjustment, do not
touch the hopper table or do not put any-
thing on the hopper table to prevent your
fingers from getting caught.
If something is caught in the mechanism,
the scanner may be damaged.