Filter
Top Products
fi-5015C Image Scanner Operator’s Guide ix
Do not install the device in locations that has oil smoke, steam,
humidity, and dust.
Turn the scanner OFF if it is damaged.
Do not put liquids inside the scanner.
Do not touch the inside of the scanner unless necessary.
Do not use the scanner if there is a strange odor.
Do not use aerosol sprays near the scanner.
Do not install the scanner in locations subject to oil smoke, steam, humidity, and dust.
Doing so might cause a fire or electric shock.
If the scanner is damaged for any reason, disconnect immediately the power plug in
order to turn out the scanner. Contact the store where you purchased the scanner.
Do not insert or drop metal objects in to the scanner. Do not scan wet documents or
documents with paper clips or staples. Do not splash or allow the scanner to get wet.
If foreign objects (water, small metal objects, liquids, etc.) get inside the scanner,
immediately turn off the scanner and disconnect the power plug from the power outlet,
then contact the store where you bought the scanner or the Maintenance Service
Center. Pay particular attention to this warning in households where there are small
children.
Do not take apart or modify the scanner. The inside of the scanner contains high-
voltage components. Touching these components might cause fire or electric shock.
If you detect excessive heat coming from the device or detect other problems such as
smoke, strange smells or noises, disconnect immediately the power plug in order to
turn out the scanner. Make sure that any smoke coming from it has stopped, before
contacting the store where you bought the scanner or an authorized FUJITSU scanner
service provider.
Do not use any aerosol sprays or alcohol based sprays to clean the scanner.
Dust blown up by strong air from the spray may enter the inside of the scanner. This
may cause the scanner to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and dirt from the
outside of the scanner may cause a fire.