Fujitsu fi-6140Z Photo Scanner User Manual


 
5
Installing the Scanner
Install the scanner in the following procedure.
1. Place the scanner at its installation site.
zfi-6130Z/fi-6140Z
zfi-6230Z/fi-6240Z
2. Unlock the transport lock switch.
For fi-6230Z/6240Z, there is a carrier unit
inside the flatbed which is fixed in place to
prevent damage during transportation.
Slide the transport lock switch on the front.
3. Attach the ADF paper chute.
Insert the tabs into the slots on the back of
the scanner, and tilt the ADF paper chute
backwards until it locks in place.
Connecting the Cables
Connect each cable in the following procedure.
1. Confirm that the computer is turned off.
2. Connect the scanner to the computer with
a USB or SCSI cable.
SCSI connection is supported by fi-6140Z/
fi-6240Z only.
Carry the scanner by supporting it
from the bottom.
301
(11.85)
158
(6.22)
380
(14.96)
700(27.56)
400
(15.75)
160(6.30)
Outer dimensions
Installation space
Unit: mm (in.)
301(11.85)
229
(9.02)
450
(17.72)
800(31.50)
400
(15.75)
567(22.32)
Outer dimensions
Installation space
Unit: mm (in.)
Locked
Unlocked
Transport lock switch
CAUTION
Only use the supplied AC adapter. Not doing
so may cause the scanner to malfunction.
USB cable and SCSI cable cannot be
connected at the same time.
ADF paper chute
Side guide
Tab
1
2
USB connector
AC cable
USB cable
Power connector
AC adapter
SCSI cable
[fi-6140Z/fi-6240Z]
SCSI connector
[fi-6140Z/fi-6240Z]
SCSI ID switch
[fi-6140Z/fi-6240Z]