RX600 S4 Options Guide 9
2Procedure
V CAUTION!
● The actions described in this manual should only be performed by
engineers, service personnel or technical specialists.
● Equipment repairs must only be performed by qualified staff.
● Any failure to observe the guidelines in this manual, and any unautho-
rized opening or improper repairs could endanger the user (through
electric shock, fire hazards) or damage the equipment.
● Please note that any unauthorized opening of the server will void the
warranty and exempt the manufacturer from all liability.
Ê First of all please familiarize yourself with the safety instructions in the
chapter “Safety instructions” on page 11ff.
Ê Make sure that all the manuals you need (see “Additional documentation
about the server” on page 6) are available, printing out the PDF files if
necessary.
You will definitely need:
– the operating manual for the server,
– the service supplement for the server, and
– the technical manual for the system board.
Ê Shut down the server correctly, switch it off, pull out the power plugs, and
open the server as described in the chapter “Preparation” on page 17f.
Ê Extend or upgrade your server as described in the relevant chapter.
I The installation and removal of the hot-plug components is described
in the operating manual supplied with the server.
Ê Close the server, plug in the power plugs, and switch on the server as
described in the chapter “Completion” on page 47f.
Ê Start the operating system and, if necessary, configure it as required (see
the operating manual).