Filter
Top Products
TABLE 10: CHANNELS PAGE DEFINITIONS
Note – The channels here are basically SIP endpoints that will act as
clients registering to the SIP Server configured under the appropriate
Profile page.
Channels
It should be set same as the channel number (i.e 1, 2..4 or 8 depending on
number of FXO ports).
It is NOT the same as SIP Account ID.
SIP User ID
This is the SIP account information. Enter the SIP User ID part of the
account.
Authentication ID
SIP service subscriber’s Authenticate ID used for authentication. It can be
identical to, or different from SIP User ID.
Authentication Password
SIP account password needs to be entered here.
Note:-
A
fter entering the password, it will show up as blank but the
password still remains active.
Profile ID
Select the corresponding Profile ID (1/2/3). Profiles are SIP Server
configurations.
Call Progress Tones
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds. ON is the period of ringing (ON time in
ms) while OFF is the period of silence. In order to set a continuous ring,
OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms
and then repeat the pattern.
• “Dial tone”
• “Ringback tone”
• “Busy/Re-order tone”
• “Confirmation tone”
Please refer the document below to determine your local call progress
tones:-
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Channel Voice Settings
Channel voice settings mentioned below.
Tx to PSTN Audio Gain
(dB)
Allows user to set a value in dB for transmission to PSTN Audio Gain.
Default is 1. Range is from -12 to 12dB.
Rx from PSTN Audio
Gain (dB)
Allows user to set a value in dB for receive from PSTN Audio Gain. Default
is 0. Range is from -12 to 12dB.
Silence Suppression
This controls the silence suppression/VAD feature of G723 and G729. If set
to “Yes”, when a silence is detected, small quantity of VAD packets (instead
of audio packets) will be sent during the period of no talking. If set to “No”,
this feature is disabled.
Echo Cancellation
When set to Y, Echo cancellation is enabled.
Channel specific Setting
Channel specific settings mentioned below.
Grandstream Networks, Inc. GXW-410x User Manual Page 21 of 37
Firmware 1.0.0.53 Updated: 04/2007