Harbor Freight Tools 66550 Digital Camera User Manual


 
SKU 66550 For technical questions, please call 1-800-444-3353. Page 6
SPECIFICATIONS
CAMERA
Total Pixels
704x576 (PAL);
712x486 (NTSC)
Modulation Type FM
Bandwidth 18MHz
Power Supply 4 AA batteries
MONITOR
LCD Screen Type 2.36”TFT-LCD
Effective Pixels 480x240
Electrical Input 8-24 VDC / 450mA
Adapter Input 120 V~ / 60 Hz
Operating Temperature +14°F~+122°F
Operating Humidity 15~85%RH
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Functions
This mini water resistant camera with
3 ft. exible tubing can be used to view
hard to reach locations while displaying
real-time video images on the 2.4” Monitor.
May be used for a variety of applications
including HVAC inspection, automotive/
boat/aircraft inspection, cable routing, etc.
TO PREVENT
INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch on the
Control Handle and Monitor to
“OFF” position and unplug
the Adaptor from its electrical
outlet before performing any
adjustments, inspection,
maintenance, or cleaning
procedures.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Parts Diagram near the
end of this manual.
Inspection Camera Set Up
1. To install Batteries:
Remove screw and cover on bottom a.
of Control Handle (1).
Slide Battery Compartment out of b.
Control Handle (1) and insert four AA
batteries.
Reinstall battery compartment and c.
cover. Secure with screw.
Keyed ends
Knurled Knob
Camera
Control
Handle
2. To attach Camera (2) to Control
Handle (1):
Align keyed ends of Control Handle a.
with cable end of Camera.