Harbor Freight Tools 95592 - 1 HP Camera Lens User Manual


 
SKU 95591/95592/95593 For technical questions, please call 1-800-444-3353 PAGE 5
Do not pump hazardous materials. 6.
Do not pump explosive or ammable
materials such as fuel, oil, kerosene,
gasoline, etc. Do not pump in close
proximity to ammable or explosive
materials. Do not pump fats, oils,
salt or waste water. This Pump is
designed to move clean or dirty
water only. Do not pump water hot-
ter than 95 degrees Fahrenheit.
Secure the discharge pipe 7. (not in-
cluded) to a solid surface to ensure
the stability of the Pump.
Position the Pump on a at, level, 8.
solid surface.
OUTLET
DEVICE
CORD
Drip Loop
9. Arrange a “drip loop” in the Power
Cord connecting the Pump to a 115
volt, GFCI electrical outlet. A drip
loop is that part of the Power Cord
below the level of the outlet to pre-
vent water from traveling along the
Power Cord and coming in contact
with the outlet. If the Power Plug or
electrical outlet does get wet, do not
unplug the Power Cord. Disconnect
the fuse or circuit breaker that sup-
plies power to the Pump. Then,
unplug the Power Cord and examine
for presence of water in the outlet.
If necessary,10. have a certied elec-
trician install (within 10 feet of
where the Pump will be located)
a 115 volt, GFCI electrical outlet
that is dedicated only to the Pump.
Any outlet should be above the
water line.
NEVER raise or lower the Pump by 11.
its electrical Power Cord.
In cold weather, when the Pump 12.
is not in use, protect the interior
of the Pump from freezing by
draining the water and pumping a
permanent type automobile anti-
freeze containing a rust inhibitor
through the system. A 50% mixture
with water is recommended. Be sure
to ush the system with a neutralizing
liquid prior to re-use of the Pump.
If an extension cord is used (for 13.
temporary use only) connections
must not come in contact with wa-
ter or any wet surfaces.
Prior to use, and periodically 14.
thereafter, check to make sure all
connections are tight and secure.
Industrial applications must follow 15.
OSHA requirements.
People with pacemakers should 16.
consult their physician(s) before
use. Electromagnetic elds in
close proximity to heart pacemak-
er could cause pacemaker interfer-
ence or pacemaker failure.
The warnings and cautions dis-17.
cussed in this manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into
this product, but must be supplied
by the operator.