Filter
Top Products
10
PAL mode change
Operation：The following processings are performed at the
time of NTSC mode .
① Push left button.（5 times）
② Push Down button.
LED lights up red.
When it pushes except Down button, the change to
NTSC mode is canceled.
A change in PAL mode is canceled at the time of
PAL mode (LED lights up green).
When it is canceled, LED blinks green.
③ LED is turned on orange after putting out lights of
LED. → LED lights up green. (a camera reboots)
④ A PAL picture is displayed in about ten seconds.
NTSC mode change
Operation：The following processings are performed at the
time of PAL mode.
① Push Right button.（5 times）
② Push Down button.
LED lights up red.
When it pushes except Down button, the change to
NTSC display mode is canceled.
A change in PALmode is canceled at the time of
NTSC mode (LED lights up green).
When it is canceled, LED green.
③ LED is turned on orange after putting out lights of
LED. → LED lights up green. (a camera
reboots）
④ A NTSC picture is displayed in about ten seconds
Caution!
Please do not turn off the power by any means during
the change of output mode.
NTSC／PAL mode change
HD-SDI／HD-VLC mode change
Button operation at a camera start-up
(1) Starting in HD-SDI mode
A power supply is started pushing an Up button.
(2) Starting in HD-VLC mode
A power supply is started pushing a Right button.
※Exclusive multiunit MU-HD101 is required for HD-VLC
mode.
A
n optional remote plug is available to enable remote
controlling of the B/W MODE and scene file. The plug is wired
as shown in the figure and connected to the remote connector
of the camera rear panel.
Remote-contact operation
Note
1) Nothing should connect with NC pin.
2) Please perform extraction and insertion of a remote plug
after turning off a camera power supply.
Remote plug (option)
D-sub 9 pin (female)
Scene file setting
Pin No. Signal name
1 N.C.
2 Serial data camera input
3 Serial data camera output
4 GND
TV FORMAT MENU
……1080i 59.94Hz
……1080i 50Hz
……1080p 29.97Hz
……1080p 25Hz
(1) 1080i 59.94Hz (NTSC MODEONLY)
(2) 1080i 50Hz (PAL MODE ONLY)
(3)1080p 29.97Hz (NTSC MODE ONLY)
(4)1080p 25Hz (PAL MODE ONLY)
Operation：Select TV FORMAT by Up (Down) button, and
press Right button.