Getting Started
25
Inserting and Removing Cassettes
A power source must be connected before inserting or removing cassettes. Once
connected cassettes can be inserted or removed whether the CAMERA/OFF/VIDEO
switch is on or off.
Inserting a Cassette
1. Slide the EJECT switch in the direction of the arrow. The cassette door opens
automatically.
2. Place the cassette in the cassette holder so that the transparent window faces away
from the body of the camera/recorder and the sprockets toward the body of the
camera/recorder.
3. Push the cassette holder, which is embossed PUSH on the left hand side, until it
"clicks" into place. The camera/recorder automatically closes.
Caution: Be sure that you push the cassette holder embossed PUSH to close the holder.
Otherwise, the holder will not click into place and the tape may be slack which could lead to
damage.
Note: If EJECT or TROUBLE flashes in the viewfinder, remove the cassette and check that
the tape is not damaged, is not slack or no dust adheres to it, etc. After making sure that
there is no abnormality, reinsert the cassette. If EJECT or TROUBLE reappears, see
"Troubleshooting" on page 46.
Removing a Cassette
Slide the EJECT switch in the direction of the arrow. The cassette door opens
automatically. Remove the cassette.