Filter
Top Products
Advanced Techniques - 47 -
hold it. If the remote control code has been set, the VCR channel is counted up automatically.
Note: Your VCR should have an infrared remote control.
Note: If the channel on the VCR does not change with the above operation, you need to
switch the remote control code of your VCR. Refer to the VCR's instruction manual. If the
channel still does not change after you have changed the VCR's remote control code, the edit
remote control cannot operate your VCR.
VCR Brands Press VCR SET and This Button
Hitachi REVERSE
Sony PROGRAM
Panasonic FORWARD
Toshiba IN
Mitsubishi COPY START
Sanyo OUT
Sharp
NEC
JVC
Akai A/V DUB
Gold Star
PHILIPS
RCA DISPLAY
Zenith COUNTER RESET
Magnavox TITLE ON/OFF
Note: The remote control code is held in memory until it is changed or the batteries are
replaced.
Note: Point the remote control straight at the VCR's infrared receiver for operation.
Note: Use the remote control indoors. When the infrared receivers of the VCR and
camcorder are exposed to direct sunlight or strong artificial light, the remote control may not
operate correctly.
Note: The remote control cannot be operated if there is an obstacle between the remote
control and infrared receiver. Especially, be careful of this during dubbing.
Note: When the edit remote control is connected to the camcorder, the buttons marked * in
the figure above perform the same operations as those of the other remote control provided.
Operation
You can select up to four different scenes or segments to be copied at one time.
Note: If sunlight or strong artificial light strikes the camcorder's infrared receiver, the editing
operation may not be possible.
Programmable Edit Hookup
1. Connect the edit remote control to the camcorder, and then connect the AV stereo output cable
as illustrated above.
2. Insert a recorded tape into the camcorder.