Filter
Top Products
PhotoBooth Assembly
Page 13
Preparing the Wireless Trigger
1. Slide the battery door off.
2. Insert a 12V battery into the wireless receiver, being careful of the battery orientation, and
slide the battery door back on.
3. Slide the wireless receiver onto the bottom of the hot shoe.
4. Slide the hot shoe to the camera. Note: The receiver can also be attached using Velcro tape
to the back of Mondopad.
5. Attach the sync cable from the sync socket on the back of the flash unit to the hot shoe.
Note: Secure excess cable to avoid tripping hazard.
6. Attach the receiver cable to the Remote Control Terminal on the camera and attach the
other end to the receiver.
Receiver Cable (to Receiver)
Sync Cable (to Flash Unit)
Hot Shoe & Receiver