Filter
Top Products
Page 22 Troubleshooting
Verify that the camera power switch is
turned on.
Turn the camera off and on again.
Verify that the camera’s SD memory card
is not full.
Verify that the camera’s SD memory card
is properly installed and that the card cover
is closed.
Verify that the SD memory card write-
protect switch is set to the upward position
to enable writing and erasing.
Verify the AC adapter is properly
connected. If using the camera’s battery
pack, verify that the battery is fully charged
and in the correct orientation.
Verify that the battery cover is closed.
Verify that the power outlet is good.
If the camera’s LCD monitor displays an
error, refer to the camera manufacturer’s
reference guide.
The camera turned off.
Press the Disp. Button on the camera.
(Note: The camera will turn off after 30
minutes of inactivity unless this feature is
deactivated. See the camera
manufacturer’s reference guide for more
information.
The camera LCD monitor is displaying an error
message.
Refer to the camera manufacturer’s
reference guide.
For additional troubleshooting support, please refer to the original manufacturer’s
documentation or contact:
InFocus Corporation
Technical Support
6am-5pm PST
877-388-8385
www.infocus.com/support