Filter
Top Products
4
Important notice:
Use only with approved mount systems that will not put pulling pressure directly on cable connector.
Improper pulling on cable/connector can damage connector and is not covered by warranty.
WARNING: Do not attempt to take apart the camera-there are high voltage parts and dangerous
electric shock can occur.
WARNING: If the camera is dropped or smashed and internal parts are exposed, do not touch-
there is a danger of electric shock.
Do not leave the camera in direct sunlight or near heat sources as these can damage the camera.
If camera becomes hot during use, turn off the power immediately.
For storage, remove the memory card and keep camera in a cool, dry place with housing door
slightly open.
Before each use, clean and maintain all O-rings in areas that have been opened by removing any
dirt, sand and any other debris
O-rings should be visually inspected and lightly lubricated as needed with silicone grease to prevent
drying and cracking. Remove all excess grease after application.
If camera stops responding to button controls, reset camera by inserting the end of a paper clip into
the reset hole (please see page 4).
Computer requirements for 1080p HD video:
Minimum recommended setup for viewing and editing 1080p 30fps video.
PC
Mac
Windows® 7, 8, 10
Mac OSR X 10.6.3 or later
Intel® Core 2 Duo
TM
or faster
Intel® Core 2 Duo
TM
or faster
DirectX 10.0 or later
Minimum 2GB of system RAM
Recommended: 4GB
Minimum 2GB of system RAM
Recommended: 4GB
Video card with minimum 256MB of RAM
Video card with minimum 256MB of RAM
Recommended screen resolution 1920x1080
(minimum 1024x768)
Recommended screen resolution 1920x1080
(minimum 1024x768)
Included Accessories:
2.4G remote, micro USB cable, TV out cable, wrist strap, lens cap, quick start guide, optional accessories
sheet.