Filter
Top Products
CV-M40
17
7-2. Jumpers on board
7-2-2. Jumpers on PK8202 board
Jumpers JP5, JP6 and JP7 enable or disable the ext. trigger input, the WEN output and pixel
clock output, respectively.
7-2-1. Jumpers on PK8201 board
Jumpers JP1 and JP2 are used to select the gamma setting. See table below for options.
Please note that both jumpers must be in the “open” position to allow RS 232C setting of
gamma. If no setting is provided via RS 232C, the camera will default to gamma 1.0.
Do not set the jumpers both JP1/JP2 at short circuited, as it causes a serious damge to the camera.
Note : Gamma is set at “Setting by RS 232C interface” with 1.0.
CAUTION