Filter
Top Products
6
CV-M40
5. Pin assignment
5-1. 12 pin connector (DC IN/SYNC connector)
HR10A-10R-12PB-01 (Hirose) male
* Note : To change the signal output on pin no. 6, 7 and 9, it is necessary to make jumper setting.
See “7-2. Jumpers on board” for more informations.
When trigger signal is input at #5 of 6 pin multi connector, do not input/output HD signal at #6 of 12 pin multi
connector, as it causes a failure in Ext. trigger mode.
Do not use video output at the same time both from #4 of 12 pin multi connector and BNC connector, as it
causes a failure on video signal due to double termination
.
1.
2.
CAUTION