Filter
Top Products
CV-M40
7
5-2. 6 pin connector (TRIGGER connector)
HR10A-7R-6P (Hirose) male
* Note : To change the signal output on pin no. 5 and 6, it is necessary to make jumper setting.
See “7-2. Jumpers on board” for more informations.
When trigger signal is input at #5 of 6 pin multi connector, do not input/output HD signal at #6 of 12 pin multi
connector, as it causes a failure in external trigger mode.
1.
Do not input HD or VD signal at pin no.5, when the camera is set at Continuous mode.2.
CAUTION