Filter
Top Products
CV-M30
4. Locations and Functions
Fig. 1. Locations
1. 1/2” interline-transfer type CCD sensor
2. Lens mount for C-mount lenses. *1)
3. BNC connector for video output
4. Switch block SW1 for shutter speed and function mode setting
5. 6-Pin connector for Input/output of control signals
6. 12-Pin connector for 12V DC power and external sync signals
7. Gain potentiometer for manual gain adjustment
8. Screw holes for Tripod mount plate. (Screws 3.0 x 5mm)
9. Tripod mount plate to place the camera on a tripod
Note *1): Rear protrusion on the C-mount lens must be less than 10mm (0.4 inches approx.).
When IR-cut filter is used, it must be less than 7.0 mm (0.28 inches approx.).
The IR-cut filter is placed in the C-mount thread.
The C-mount IR-cut filter must be ordered separately.
- 3 -