Filter
Top Products
IIT Camera System Manual
36 Appendix D
7 Appendix C: VIS-CAM 400 IIT-2030 and VIS-CAM 400 IIT-2076
The VIS-CAM 400 IIT-2030 and VIS-CAM 400 IIT-2076 are made a little different from the VIS-CAM 350
IIT cameras. The picture below shows the VIS-CAM 400 IIT overview
Figure 34. VIS-CAM400IIT-2030 and VIS-CAM400IIT-2076 overview
Note: The TS-9725EN camera is not powered. Only fiber front is exploited. Do not adjust the
mechanical mount for this camera.
The fiber assembly in the IIT cameras is made from 8 x 1mm fibers giving a total width of 8mm. This
coverage fits the 2/3” CCD fine in the TS-9725EN and TS-1335EN (VIS-CAM350IIT) cameras having a
sensor width of 8.8mm.
The width of the sensors in the TS-2030EN and the TS-2076EN, used in VIS-CAM400, is 14.2mm and
the fiber assembly is too small to cover the width of this sensor. A solution using two cameras has
therefore been chosen where the trigger unit is a TS-9725EN camera. Only the fiber front of this
camera is exploited and the camera does not need to be powered except when alignment is
performed at factory. The TS-9725 camera is mounted with a 25mm lens and the TS-2030EN/TS-
2076EN with a 35mm lens giving almost the same field-of-view for the two cameras.
Having the camera and trigger unit separated this way, makes it possible to adjust the trigger-line
within the picture height, to some degree, by adjusting the camera mount inside the housing. As for
the single camera version, the camera with the fiber front, may not be adjusted. This has been
done from the factory to cover the IR illuminated area.
Please see appendix E regarding connection of floodlight for VIS-CAM 400 IIT.
Apart from the described differences, the setup and configuration is the same as the single camera
version.