JVC 0206ASR-NF-VM Camcorder User Manual


 
EN 43
EDITING
MasterPage: Start_Right
ADVANCED FEATURES
It is also possible to copy recorded scenes from
the camcorder onto another video unit equipped
with a DV connector. Since a digital signal is
sent, there is little, if any, image or sound
deterioration.
To use this camcorder as a player
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3 Start playback on the camcorder. ( pg. 21)
4 At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
units instruction manual.)
5 To stop dubbing, stop recording on the video
unit, then stop playback on this camcorder.
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
pg. 15)
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If
this occurs, turn off the power and make
connections again.
If Playback Zoom ( pg. 25) or Playback
Special Effects (
pg. 25) is attempted or
SNAPSHOT is pressed during playback, only the
original playback image recorded on the tape is
output from the DV IN/OUT connector.
When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U DV
cable.
To use this camcorder as a recorder
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit
equipped with a DV output connector using a DV
cable as shown in the illustration.
3 Set the camcorders Power Switch to PLAY.
4 Set REC MODE to SP or LP. ( pg. 35)
5 Start playback on the player.
6 Press the Recording Start/Stop Button to
engage the Record-Pause mode.
The “” indication appears on the
screen.
7 At the point you want to start dubbing, press
the Recording Start/Stop Button to start
dubbing. The indication rotates.
8 Press the Recording Start/Stop Button again
to stop dubbing. The indication stops
rotating.
9 Press 7 to return to the normal playback
mode.
NOTE:
Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current SOUND MODE setting. (
pg. 32)
Dubbing To Or From A Video Unit
Equipped With A DV Connector
(Digital Dubbing)
Core lter
To DV IN/OUT
DV cable (optional)
To DV IN/OUT
Video unit equipped with DV connector
DV IN
GR-D390US.book Page 43 Wednesday, June 21, 2006 9:55 AM