JVC 0206ASR-NF-VM Camcorder User Manual


 
MasterPage: Heading0_Left
46 EN
TROUBLESHOOTING
If, after following the steps in the chart below, the
problem still exists, please consult your nearest
JVC dealer.
Power
The power is not connected properly.
Connect the AC Adapter securely. ( pg. 14)
The battery pack is not attached rmly.
Detach the battery pack once again and re-attach
it rmly. ( pg. 14)
The battery is dead.
Replace the dead battery with a fully charged
one. ( pg. 14)
Video and D.S.C. Recording
The tapes erase protection tab is set to SAVE.
Set the tapes erase protection tab to REC.
( pg. 18)
TAPE END appears.
Replace with new cassette. ( pg. 18)
The cassette holder cover is open.
Close the cassette holder cover.
This is not a malfunction.
This is not a malfunction.
DATE/TIME is set to OFF.
Set DATE/TIME to ON. ( pg. 31, 34)
Effects and DIS functions that cannot be used
together are selected at the same time.
Re-read the sections covering Effects and DIS.
( pg. 31, 32, 41)
32X optical zoom is selected.
Set ZOOM to 64X or 800X. ( pg. 33)
The VIDEO/MEMORY Switch is set to
MEMORY.
Set the VIDEO/MEMORY Switch to VIDEO.
Video and D.S.C. Playback
Your TV has AV input terminals, but is not set to
its VIDEO mode.
Set the TV to the mode or channel appropriate for
video playback. ( pg. 23)
The cassette holder cover is open.
Close the cassette holder cover. ( pg. 18)
Clean the video heads with an optional cleaning
cassette. ( pg. 52)
Advanced features
Focus is set to the Manual mode.
Set Focus to the Auto mode. ( pg. 37)
The lens is dirty or covered with condensation.
Clean the lens and check the focus again.
( pg. 50)
The Wide (16:9) mode (16:9 indicator) is
selected.
Disengage the 16:9 (16:9 indicator) Wide mode.
( pg. 36)
The camcorder is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from
functioning properly. In such cases, rst
disconnect its power supply unit (battery pack,
AC Adapter, etc.) and wait a few minutes; and
then re-connect it and proceed as usual from
the beginning.
No power is supplied.
Recording cannot be performed.
When shooting a subject illuminated by
bright light, vertical lines appear.
When the screen is under direct sunlight
during shooting, the screen becomes red or
black for an instant.
During recording, the date/ time does not
appear.
The LCD monitor or viewnder indications
blink.
Digital Zoom does not work.
The tape is moving, but there is no picture.
Blocks of noise appear during playback, or
there is no playback picture and the screen
becomes blue.
The focus does not adjust automatically.
Snapshot mode cannot be used.
REFERENCES
GR-D390US.book Page 46 Wednesday, June 21, 2006 9:55 AM