Filter
Top Products
EN 49
OFF
P
L
A
Y
A
M
5S
MENU
4
You can watch what you’ve recorded in the LCD monitor.
Playback Sound
You can hear sound from the speaker or using
headphones connected to the headphones connector
during playback. To adjust the sound volume, press
the VOL. switch. The sound volume indication is
displayed. Slide the VOL. switch towards “+” to turn
up the volume, or towards “–” to turn it down.
Still Playback
To temporarily stop playback, press 6/
4
. Press
again to resume playback. If still playback contin-
ues for more than about 3 minutes, the camcorder’s
Stop mode is automatically engaged. After 5
minutes in the stop mode, the camcorder’s power is
automatically turned off.
Slow-Motion Playback
● To perform Slow-motion playback, the remote
control is necessary.
● To change from normal to slow-motion playback,
press the Pause button at the point where you want
to start playback in slow motion, and press the Slow
Rewind or Slow Forward button on the remote
control unit. After playing back in slow motion for
about 10 to 20 seconds, normal playback resumes.
Speed is 1/10 times normal. To stop slow-motion
playback in progress, press the Play button.
● During slow-motion playback, due to digital image
processing, the picture may take on a mosaic effect.
● After the Slow Rewind or Slow Forward button is
pressed, the still image may be displayed for a few
seconds, then the screen may become blue back for
a few seconds. This is not a malfunction.
● There may be a small margin between the slow-
motion playback start point you chose and the start
point at which the camcorder actually begins
playback in slow motion.
NOTES:
●
The sound is not available during High-Speed Search.
●
Copy guarded tapes cannot be played back. The
screen becomes blue back.
1
SELECT OPERATION MODE
Turn the Power Dial to “PLAY” while pressing
down the lock button located on the dial. The
Power lamp comes on.
2
OPEN LCD MONITOR
Open the LCD monitor.
•When the viewfinder is pulled out, the LCD
monitor cannot be used.
3
REWIND TAPE
Press
2
.
2
is displayed. If you rewind all
the way to the end of the tape, it stops
automatically.
4
VIEWING RECORDING
Press 6/
4
.
4
appears and the recorded
footage can be viewed. The sound is heard
from the speaker.
5
END PLAYBACK
Press 5. Set the Power Dial to “OFF”.
•When turning to “OFF”, it is not necessary to
press down the lock button.
To Perform High-Speed Search . . .
..... press
2
or
3
after pressing 6/
4
. The tape
will move at approximately 9 times the normal
playback speed. Watch in the LCD monitor and,
when you reach the spot you want to see, press
6/
4
and normal playback resumes.
..... during playback, press and hold
2
or
3
. The
search continues as long as you hold the button.
Once you release it, normal playback resumes.
..... a slight mosaic effect appears on screen during
High-Speed Search. This is not a malfunction.
PLAYBACK
Basic Playback
Power Dial
Lock button
Tape running indiator
LCD monitor
Power lamp
Speaker
Volume switch