JVC 0797TOV*UN*SN Camcorder User Manual


 
EN 65
Audio Dubbing
The audio track can be customized only when recorded on the 32 kHz mode ( pg. 35).
NOTE:
Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a
blank portion of a tape.
TW
6e
MIC
DC-IN
1
FIND EDIT-IN POINT
Play back the tape to locate the point where
editing will start, then press PAUSE.
2
ENGAGE AUDIO DUB STANDBY
While holding A. DUB on the remote control,
press PAUSE. “6e” appears.
RECORDING SOUND DISPLAY OUTPUT SOUND
32 kHz FULL SOUND Original and new tracks are combined and output in stereo.
SOUND 2 New track is output on both “L” and “R” channels in stereo.
SOUND 1 Original track is output on both “L” and “R” channels in stereo.
Speaker
3
BEGIN DUBBING
Press PLAY, then begin “narrating”.
•Speak into the microphone.
4
PAUSE DURING DUBBING
Press PAUSE.
5
STOP DUBBING
Press STOP.
Audio Dub Standby
Stereo microphone
Power Dial
Remote sensor
RM-V711U
(provided)
PLAY
STOP
PAUSE
A.DUB
AUDIO
MONITOR
DISPLAY
External microphone
input connector
(Located beneath
the cover.)
NOTES:
Audio dubbing is possible using an optional microphone connected to the external microphone input
connector (MIC).
While an optional microphone is connected, the built-in microphone is disabled.
When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.
To select the desired sound for playback, press AUDIO MONITOR on the remote control.
If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded
areas.
If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV,
or turn down the TV’s volume.
Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones
to the AV-OUT (headphones) jack.
If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not
effective from the point where 48 kHz recording began.
During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz
or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.