Filter
Top Products
11
Camera control unit (rear panel)
1
Lens mount ring
Standard C mount is used.
Flange back will be 17.526mm in air.
2
Camera cable connector (plug)
Connect to camera control unit.
Camera head
~AC IN
NTSC OUT SXGA OUT
GBR
DV Y
PB
PR
Y/C
(S)
VBS
HD OUT
GENLOCK
IN/OUT
6 7
53
1
2
4
2
1
[AC INPUT] power input connector
To input AC120V.
2
Equal-potential connector
3
Cover for extension slot
Remove the cover to install an optional device in
this slot.
4
[NTSC OUTPUT] NTSC output section
Output of DV signals, Y/C(S) signals, VBS (compos-
ite video signals).
The power supply for IEEE1394 interface is not
available from DV connector.
5
[GENLOCK IN/OUT] sync signal input/output
Input/output of composite sync signal for external
sync. (menu-based switching).
6
[SXGA OUT] SXGA output section
Output of progressive scan GBR signal.
SXGA output signal cannot be displayed on the DT-
V1900CG.Use the monitor that is compliant with the
following scanning frequency.
Horizontal: 67.4325kHz, vertical: 59.94Hz
7
[HD OUT] video signal output section
Output of HD (Y, PB, PR) video signals (interlace
scan).
When HD video signals are connected to Hi-vision
monitor, the screen will have a width/length ratio of
16:9, and the picture will extend sideways.