Filter
Top Products
18
System operation
AC 120V
Connector
Connector Cap
Mark (Red)
Camera head
CCU
Camera control unit
DZ-VCA3U
SR-W7MAU (W-VHS)
(Optional)
DT-V1900CG
(Optional)
Isolation transformer AA-V31U
(Optional)
ON I
O
OFF
POWER
CAMERA
SETTING
RED BLUE
WHITE BALANCE
AUTO MANUAL ON OFF
ENHANCE FREEZE BAR
MENU SETTING
GAIN SHUTTER
OUTPUT LEVEL
ADJUST
AUTO MANUAL
CAMERA
VOLUME
SLOT 1
A
B
DEGAUSS
MENU
MUTING
SCREENS
CHECK
ASPECT
AREA
MARKER
UNDER
SCAN
PULSE
CROSS
COLOR
OFF
SLOT 2
C
D
SLOT 3
POWER
E
F
INPUT SELECT
Check system operation according to the following
procedures.
1. Insert the camera connector while aligning it to the red
mark as shown on the left figure.
When cap is connected to the camera connector:
Turn the cap counterclockwise to remove it.
2. When the camera is used as a system, connect the power
plugs of the camera and other equipments to the isolation
transformer AA-V31U.
3. Switch on isolation transformer AA-V31U power switch.
4. Switch on DZ-VCA3U power.
5. Switch on W-VHS power.
Insert W-VHS tape, and make sure that it can record.
6. Switch on the power of monitor.
Check that picture taken by camera can be displayed on
the monitor.
7. Operate each device according to its operating procedure.
Note :Consult JVC service personnel or authorized dealer
when connecting the system for the first time.
Do not disconnect, or modify the connection by
yourself.
Basic operation (Continued)
Operation of Micro HD camera
Check system operation according to the following
procedures.
1. Insert the camera connector while aligning it to the red
mark as shown on the left figure.
When cap is connected to the camera connector:
Turn the cap counterclockwise to remove it.
2. Connect the endoscope adapter to the C mount of camera
head.
3. When operating this system, set the switches on the CCU
panel as follows:
1) OUTPUT LEVEL :[AUTO]
2) WHITE BALANCE : [AUTO]
3) MENU SETTING :[OFF]
4. Switch on DZ-VCA3U power.
5. Adjust the white balance.