Filter
Top Products
Notes:
z
When the storage memory is full, you may either erase the video clips that are no more required, or insert a new
memory card.
z
The remaining shooting time shown on the LCD monitor is an approximate value based on the currently accessed
memory size.
z
The actual number of seconds available for shooting also depends on the shooting conditions. The value does not
necessarily decrease by the second. Also, upon turning on the camera, memory adjustment is made and the
available time may actually be more than when the camera was last turned off.
z When you take pictures in bright locations or in clear fine weather, lines may appear on the monitor. This is not a
malfunction.
z
Press the shutter button down steadily.
z When the status indicator is lit, shooting/replay is not possible. Wait until the light goes off. (After shooting a video
clip, you would have to wait a little while for the pictures to be stored into memory. A few seconds is also required t
o
load the images from the memory to the LCD monitor for replay).
z
Never open the Battery/Memory Card compartment door when the status indicator is lit for this may cause damage
.
z Please format new Memory cards with this camera before using them.
z
In the Video Clip mode, the following functions are not possible.
* Voice/sound recording.
* Use of flash.
* Self-Timer.
* Zoom.
* Image Quality setting. (The Video Clip mode resolution is fixed at 320x240.)
* Display ON/OFF.
z
We recommend that you take some test shots to get accustomed to the camera before you actually start.
z
We cannot bear any responsibility for an inability to record or replay material normally, in the event of a problem wi
t
this camera.
z
Store backups of important video clips in eg. your personal computer. We cannot bear any responsibility for any lo
s
or alteration to the images stored in the camera’s internal or external memory.
z It is prohibited to use video clips taken with this camera for commercial purposes without the consent of the copyrig
owner.
z
Do not turn the Normal /Macro switch dial unnecessarily. It may become malfunction.
z
Please take note not to touch the lens when turning the dial.