Filter
Top Products
EN 9
Charging Environment
Perform charging where the temperature is between 10° and 30°C. (20° to 25°C is the ideal temperature range for
charging.) If the environment is too cold, charging may be incomplete.
Continuous Shooting
Continuous shooting is possible (See table below for recording time) under the following conditions:
•The temperature is approximately 20°C
However, . . .
•If the temperature is below 10°C, or
•If zoom or Record-Standby are engaged or LCD monitor is used repeatedly, continuous shooting capability
is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to
cover 3 times the planned shooting time.
1
OPEN BATTERY COVER
Slide the open switch.
2
INSERT CHARGED BATTERY
Insert the mark end of the battery first until
you hear a click. The hook rises. Inserting the
battery backwards will result in malfunction.
3
CLOSE BATTERY COVER
Battery
Battery cover
Hook
Open switch (BATTERY)
NOTES:
●
To remove the battery, turn off the camcorder,
open the battery cover and push down the hook.
●
Be careful not to drop the battery pack.
●
The hook is tight to prevent the battery from
dropping.
●
See the Additional Reference Manual for more
information on using the Battery Pack BN-V856U.
Approximate recording time
Battery Pack
BN-V814U
BN-V856U
LCD monitor off/Viewfinder on
1 hr. 40 mim.*
3 hrs.**
6 hrs.
LCD monitor on/Viewfinder off
1 hr. 20 mim.*
2 hr. 20 mim.**
5 hrs.
* Using one battery installed in the camcorder
** Using two batteries; one in the camcorder and one in the provided Power Pack attached to the camcorder
Installing The Battery Pack
The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has
been charged fully.