Filter
Top Products
68 EN
PAUSE
START/STOP
INSERT
PLAY
REW
6w
STOP
12:34
USING THE REMOTE CONTROL UNIT
(cont.)
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in and outpoints. The
original audio remains unchanged.
NOTES:
●
Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen
(
੬
pg. 43, 45).
●
Insert Editing is not possible on a tape recorded in the
LP mode or on a blank portion of a tape.
●
To perform Insert Editing while watching in the
television, make connections (
੬
pg. 24).
1
Play back the tape, locate the Edit-Out point and
press PAUSE (6). Confirm the time code at this
point (੬ pg. 43, 45).
2
Press REW (2) until the Edit-In point is located,
then press PAUSE (6).
3
Press and hold INSERT (w) on the remote control,
then press PAUSE (6). “6w” and the Time Code
(min.:sec.) appear and the camcorder enters Insert-
Pause mode.
4
Press START/STOP to begin editing.
•Confirm the insert at the time code you checked
in step 1.
•To pause editing, press START/STOP. Press it
again to resume editing.
5
To end Insert Editing, press START/STOP, then
STOP (5).
NOTES:
●
Program AE with special effects (
੬
pg. 48, 49) can be
used to spice up the scenes being edited during Insert
Editing.
●
During Insert Editing, the date and time information
changes.
●
If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make
sure you only edit recorded areas.
●
During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert
Edting stops (
੬
pg. 91).
Display
Remote sensor