Filter
Top Products
14 EN
GETTING STARTED
MasterPage: Body_Left
This camera’s 2-way power supply system lets you
choose the most appropriate source of power. Do not use
provided power supply units with other equipment.
Charging the Battery Pack
1 Set the power switch to OFF while pressing down the
lock button located on the switch.
2 Slide and remove the battery cover A by hooking on
the part with your finger.
3
Insert the battery pack firmly into the battery pack mount
until it locks into space in the direction of the arrow
B
.
4 Close the battery cover firmly until it locks.
5 Connect the AC adapter to the camera, then connect
the power cord to the AC adapter.
6 Plug the power cord into an AC outlet. The power/
charge lamp on the camera blinks to indicate charging
has started.
7 When the power/charge lamp goes out, charging is
finished. Unplug the power cord from the AC outlet.
Disconnect the AC adapter from the camera.
To detach the battery pack
Open the battery cover, and remove the battery pack in
the direction of the arrow C by holding the part.
Power
To AC outlet
Power/Charge
Lamp
Battery Pack
AC Adapter
Open the cover.
Power Switch
To DC
connector
Lock Button
Battery Cover
Protrusion
Power Cord
Battery pack Charging time
BN-VM200U (provided) Approx. 1 hr. 35 min.
GZ-MC100PAL.book Page 14 Tuesday, December 28, 2004 1:04 PM