Filter
Top Products
23
Fill the piping hole and mounting hole with a
sealing material, mount the camera unit to the
base, and insert the silica gel.
1.Fill the hole with sealing material
Fill the piping hole as well as the 2 mounting
holes mounted with screws using a sealing
material.
Memo:
● Use GE silicon or its equivalents as the
sealing material.
Note:
● If the piping hole and the 2 mounting holes
mounted with screws are not filled with
sealing material completely, water or vapor
may enter the holes causing the lens and
dome cover to fog. Make sure that these
holes are completely filled.
2.Mounting the camera unit to the base
Press the 2 clips until a “click” sound is heard.
Note:
● Mount such that the cables and fall
prevention wire of the dome cover are not
clamped.
3.Fastening the 2 fastening screws of the
camera unit
Tighten the 2 fastening screws of the camera
unit using a screwdriver to fasten the camera.
Mounting the camera unit
Sealing Material
2
3
Clip
(x 2)
*TK-C215VP4U/E is used in the above illustration
TK-C215VP4_JP.book Page 23 Thursday, November 2, 2006 10:51 AM