Filter
Top Products
56 EN
EDITING
(Cont.)
Audio Dubbing
Using a tape recorded at 32 kHz, you can customize the soundtrack of a tape you’ve recorded.
NOTE:
Audio Dubbing is not possible on a tape recorded at 48 kHz.
4
PAUSE DURING DUBBING
Press PAUSE.
5
STOP DUBBING
Press STOP.
NOTES:
●
When editing onto a tape that was recorded at 32 kHz,
the old and new soundtracks are recorded separately.
●
To select the desired sound for playback, press AUDIO
MONITOR on the remote control.
●
If you dub onto a blank space on the tape, the sound may
be disrupted. Make sure you only edit recorded areas.
●
If feedback or howling occurs, move the Docking
Station so the camcorder’s microphone is away from the
TV, or turn down the TV’s volume.
●
If you change from 32 kHz to 48 kHz in mid-recording
and then use the tape for Audio Dubbing, it is not
effective from the point where 48 kHz recording began.
1
FIND EDIT-IN POINT
Play back the tape to locate the point where
editing will start, then press PAUSE.
2
CONNECT EXTERNAL
MICROPHONE
Connect an optional stereo microphone. Then
while holding A. DUB on the remote control,
press PAUSE.
•Pull out the viewfinder and “6e” appears.
•Press DISPLAY on the remote control if
sending the image to a connected TV.
3
BEGIN DUBBING
Press PLAY, then begin “narrating” using the
external microphone.
6e
TW
POWER DIAL
REMOTE SENSOR
AUDIO DUB STANDBY
A.DUB
PLAY
PAUSE
EXT. MIC INPUT
CONNECTOR
DISPLAY
STOP
AUDIO MONITOR
RM-V708U (provided)
RECORDING SOUND DISPLAY OUTPUT SOUND
32 kHz FULL SOUND Original and new tracks are combined and output in stereo.
SOUND 1 Original track is output on both "L" and "R" channels in stereo.
SOUND 2 New track is output on both "L" and "R" channels in stereo.