Filter
Top Products
3-6
Calibrating the Printer
16. Click Select to change the media file for your printer.
A file selection dialog box appears.
17. Select the media file and then click OK.
18. Click OK to close the dialog box.
19. Click Next.
The following dialog box appears.
20. Confirm that the Printer and Printer Setup information are correct.
• If the information is not correct and you have more than one media
file, click Back and go to Step 15.
• If the information is correct, click Next to send the default table to the
printer.
NOTE: The existing calibration table in the printer is overwritten.
The following dialog box appears.