Filter
Top Products
48 www.kodak.com/go/support
Troubleshooting
Camera ready light status
If... Try one or more of the following
Ready light does
not turn on and the
camera does not
work
■ Turn on the camera (page 2).
■ Recharge the battery or install a new one (page 1).
■ Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
Ready light blinks
green
■ Picture is being processed and saved to the camera. Camera is
operating normally.
■ Camera is connected. Camera is operating normally.
Ready light blinks
red and camera
turns off
■ Recharge the battery or install a new one (page 1).
Ready light glows
steady green
■ Shutter button is pressed halfway down. Focus and exposure are set.
Camera is operating normally.
Ready light glows
steady orange
■ The Mode dial is set to Favorites. Camera is operating normally.
Ready light blinks
orange
■ Flash is not charged. Wait. Resume picture taking when the light stops
blinking and turns off.
■ Auto exposure or auto-focus are not set. Release the Shutter button
and recompose the picture.
Ready light glows
steady red
■ Camera’s internal memory or card is full. Transfer pictures to the
computer (page 17), delete pictures from camera (page 14), switch
image storage locations (page 33), or insert card with available
memory (page 3).
■ Camera processing memory is full. Wait. Resume picture-taking when
the light turns off.
■ Card is read-only. Change image storage location to internal memory
(page 36), or use a different card.