Filter
Top Products
Troubleshooting
www.kodak.com/go/support
50
Picture quality problems
Status Cause
The picture is too dark or
underexposed
■ Use Fill flash (page 16) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within
the effective flash range (page 16).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■ Decrease the shutter speed or increase the ISO speed (page 14).
The picture is too light
■ Turn flash off (page 16).
■ Move so that the distance between you and the subject is within
the effective flash range (see page 16).
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■ Increase the shutter speed or decrease the ISO speed (page 14).
The picture is not clear
■ To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■ Clean the lens (page 57).
■ Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod.